NanoSIMS Distinguishes Intact Nanoparticles from Dissolved Species Inside Cells

Where do nanoparticles go once they enter a cell, and do they remain unchanged?

 

NanoSIMS uniquely distinguishes intact nanoparticles from dissolved elemental species inside cells.

Cell Imaging

A recent study used this capability to investigate the fate of barium sulfate nanoparticles in human lung cells, revealing both nanoparticle localization and intracellular transformation.

 

Subirana et al. exposed normal human bronchial epithelial cells to BaSO₄-NPs and used NanoSIMS, supported by transmission electron microscopy (TEM) and inductively coupled plasma mass spectrometry (ICP-MS), to investigate their uptake and intracellular fate.

 

The study highlights one of NanoSIMS' most powerful capabilities: distinguishing intact nanoparticles from dissolved elemental species and visualizing both at subcellular resolution.

NanoSIMS Confirms Intact BaSO₄ Nanoparticles

The researchers analyzed 300 nm cell sections with a NanoSIMS (CAMECA, Gennevilliers, France).

 

Using complementary sulfur and barium maps, NanoSIMS unequivocally identified intact BaSO₄ nanoparticles and localized them within the cytosol and vesicles of lung cells.

 

The authors reported this as the first NanoSIMS demonstration of BaSO₄-NP uptake by normal human bronchial epithelial cells.

 

NanoSIMS Reveals Intracellular Particle Dissolution

Beyond particle localization, NanoSIMS revealed nanoparticle transformation, a critical aspect of nanoparticle fate that is often inaccessible to conventional imaging approaches. Part of the barium signal was no longer associated with intact BaSO₄ nanoparticles and appeared as a diffuse intracellular distribution consistent with dissolved Ba²⁺.

 

When barium ion counts were displayed on a logarithmic scale, the strong, localized signals from BaSO₄-NPs appeared alongside a weaker signal distributed through portions of the cells. The researchers attributed this diffuse signal to dissolved Ba²⁺.

 

Line scans showed that intracellular barium counts near the nanoparticles were higher than detector background outside the cells. No intact BaSO₄ nanoparticles were observed in the nucleus. However, NanoSIMS revealed that dissolved barium could spread beyond the particle-containing compartments and reach the nucleus.

 

The two forms followed different paths. Intact particles remained in the cytosol and vesicles, while barium associated with dissolution was more widely distributed and could reach the nucleus. NanoSIMS could therefore distinguish intact nanoparticles from the diffuse barium signal attributed to dissolved Ba²⁺ and map their different intracellular distributions within the same biological sample.

NanoSIMS imaging

Image: NanoSIMS imaging of three NHBECs exposed to 10 mg BaSO4 L−1 nanoparticle suspension. 12C14N mapping shows the cell morphology. 138Ba mapping is displayed in logarithmic scale (0–200 counts) and shows NP as well as dissolved barium in the cells. Dashed lines indicate the cell shapes. Line scans through the entire cells additionally confirm NPs and dissolved Ba. Scale bar 10 µm.

 

NanoSIMS Maps the Effects of Nanoparticle Aggregation

Nanoparticle aggregation also appeared to influence intracellular barium distribution.

 

At the higher exposure concentration, the particles were more aggregated, and barium was detected more often around those aggregates rather than throughout the cell. NanoSIMS imaging revealed that aggregation influenced both nanoparticle dissolution and the subsequent redistribution of barium within the intracellular environment.

 

Quantitative image analysis further supported these observations, showing a reduced cell-wide distribution of barium at higher concentrations, where nanoparticle aggregation was more pronounced. These results suggest that particle aggregation can significantly alter nanoparticle fate and elemental mobility within cells.

 

TEM and ICP-MS Support the NanoSIMS Findings

TEM and ICP-MS supplied complementary evidence.

 

TEM showed particle structures within vesicles and more pronounced aggregation at the higher exposure concentration. NanoSIMS confirmed their elemental identity by showing colocalized sulfur and barium signals.

 

ICP-MS measured a dose-dependent increase in cellular barium, confirming uptake at the bulk level. It also detected Ba²⁺ in the culture medium after 72 hours, showing that the nanoparticles were poorly soluble but not insoluble.

 

Together, the techniques provided structural, quantitative, and spatial information. While ICP-MS quantified uptake and TEM visualized particle structures, only NanoSIMS simultaneously identified elemental composition, localized nanoparticles, and visualized their intracellular transformation.

 

NanoSIMS Value for Nanotoxicology and Nanoparticle Fate Studies

NanoSIMS can distinguish and map particulate and dissolved forms of an element within the same biological sample.

Nanoparticle fate studies must determine more than whether an element enters a cell. Researchers also need to know whether the particle remains intact, where it accumulates, whether it transforms, and where its constituent elements move afterward.

 

NanoSIMS addressed the study’s questions through a distinctive combination of:

  • Elemental and isotopic specificity
  • High sensitivity, including detection of lower-intensity intracellular ion signals
  • Imaging at cellular and subcellular scales
  • Colocalization of multiple elemental signals
  • Mapping of particulate and dissolved forms within the same sample

 

In this study, the colocalization of sulfur and barium confirmed the presence of intact BaSO₄ nanoparticles, whereas a diffuse intracellular barium signal revealed the redistribution of barium released through partial particle dissolution.

 

This capability is especially valuable for nanotoxicology, where biological effects depend not only on nanoparticle uptake and accumulation but also on intracellular transformation processes. By providing direct spatial evidence of both particle integrity and elemental redistribution, NanoSIMS enables a comprehensive assessment of nanoparticle uptake, transformation, and fate within a single experiment.

 

Maria Angels Subirana
About Maria Angels Subirana

Maria Angels Subirana, Ph.D., is a Research Engineer at IPREM (CNRS/University of Pau, France) specializing in NanoSIMS-based elemental and isotopic imaging. Her research focuses on tracking trace elements and nanomaterials at the cellular and subcellular scales to better understand their distribution, transformation, and fate in biological and environmental systems.

Instrument Notes

The NanoSIMS-HR is a unique ion microprobe that optimizes SIMS analysis performance at high lateral resolution. It is based on a coaxial optical design of the ion beam and the secondary ion extraction, and on an original magnetic sector mass analyzer with multicollection.

 

For More Information

Read the scientific article: M.A. Subirana, S. Thomas, G. Hause, D. Dobritzsch, F. Glahn, D. Schaumlöffel, M. Herzberg, “Uptake, localization and dissolution of barium sulfate nanoparticles in human lung cells explored by the combination of ICP-MS, TEM and NanoSIMS,” Journal of Trace Elements in Medicine and Biology 89 (2025) 127650, doi: https://doi.org/10.1016/j.jtemb.2025.127650.

 

 

Illustration of a girl taking CAMECA e-learning training programs

Learn from Experts

We offer training for all instruments and experience levels, available online or at your lab. CAMECA accelerates your learning curve!